← Back to list

PO453 Code on 2005 Hyundai Elantra: Is It Gas Cap or a Broken Sensor?

Model: 2005 Hyundai Elantra Fault Code: P0453 Posted: 2018-11-04 16:51

Hi everyone! My 2005 Hyundai Elantra recently triggered the check engine light. After using an OBD2 scanner, I found a P0453 code — indicating an Evaporative Emissions System issue. I took it to my local Firestone mechanic, who said diagnostics alone cost $100. They didn't mention 'small' in their diagnosis, which made me suspicious. They claimed there was a specific part that was broken and would require nearly $500 to replace — but noted this repair depended on another component, potentially leading to additional costs of up to another $500. I decided to wait and monitor the situation. However, since my car failed Connecticut emissions testing, I have a limited time window to fix it or risk being unable to register the vehicle. A few weeks later — shortly after refueling — the check engine light turned off on its own. I didn’t clear it manually. When I scanned again, the P0453 code was still present. After clearing the code, a subsequent scan showed no errors. So here’s my confusion: Could this have been simply a faulty gas cap all along — even though the mechanic didn't mention 'small' in their diagnosis? If so, why did they say there was a broken part needing replacement? Also, could my scanner be inaccurate? Did it show P0453 and then disappear after clearing when the issue was still present? Would such an intermittent problem show up again quickly or would the scan return 'no codes'? I’d really appreciate any insight into whether this is a gas cap issue or something more serious like a faulty Fuel Tank Pressure (FTP) sensor. And how can I trust a diagnosis that shows a part failure but then no code appears after clearing? Thanks for your help — Diana

Related fault codes
P0453
Comments (4)
Anonymous 2018-11-04 23:34

A P0453 DTC typically indicates one or more of the following: - Open circuit in the FTP sensor signal wire - Short to voltage on the FTP sensor signal wire - Faulty Fuel Tank Pressure (FTP) sensor - Abnormally high tank pressure due to blocked EVAP purge hoses or an overfilled fuel tank - Loose or damaged FTP sensor connector - Loss of ground connection to the sensor For more details, see: https://www.autozone.com/p0453

Anonymous 2018-11-05 05:34

Thanks for the info — but I’m not looking for general causes. My specific question is about the check engine light turning off and the scanner showing no codes after refueling. Could that be a sign of an intermittent issue? How can a diagnosis state there’s a broken part when the code disappears after clearing? I need to understand this inconsistency, especially since emissions testing requires resolution before registration.

Anonymous 2018-11-05 08:06

If the check engine light turned off on its own, it may point to an intermittent electrical issue — possibly a wiring fault or a problem with the Fuel Tank Pressure (FTP) sensor. The FTP sensor replacement is a common fix for P0453. Note: After clearing the code, your vehicle may not pass emissions testing until all system monitors are fully reset and reach 'steady' status.

Anonymous 2018-11-05 10:21

+1 to Mohawkmtrs. Since you have a scanner available, try loosening the gas cap slightly and scan again. P0455, P0456, and P0457 are more directly linked to gas cap issues than P0453. You’re right to question the diagnosis — especially given the intermittent behavior of the code. If the issue is intermittent, it may not be a permanent part failure. Please update with your findings so others can benefit from your experience.