Aero cover not fully popping in, but only on one wheel

Furrypocketpussy | 2026-01-08 22:15 | 24 views

I'm at my wits end here. None of the 4 aero covers I have will properly stick to one of my wheels. They work perfectly fine for the other 3 wheels, but not for the problematic one. Rotating covers hasn't helped. There is no visible rim deformation and it doesn't appear different from the other wheels. Yet the covers will click in to only \~80% full. There is always one corner popping out. Looking for any recommendations or suggestions Edit: for anyone interested in the "solution", I bought 4 more covers off marketplace after the loose one flew off. Of these 4 new ones, only only properly clicked in. For whatever reason, it took a specific cover to work. No differences that I can see between this one and the rest

Comments (4)

stuffedbipolarbear 2026-01-09 00:04

This might be a dumb question but are you lining up the valve stem to the slot on the cover?

my10ro_NO_F1 2026-01-09 00:05

I think you may have answered your own question. No visible rim damage….Since the aero covers are all inserts if that wheel has bend/warping then this might explain your issue. Standard questions: When was the last time you got new tires? How’s the alignment? Have you inspected the wheel after removing it from the vehicle?

xylarr 2026-01-09 02:16

The current Model 3 Performance wheels are the worst. I took out the covers, 5 per wheel, to show more of the brakes - plus I think they look good. That process was difficult enough. Then just recently I was planning to drive a couple of thousand kilometres. Before the trip, I thought I would pop back the covers so I'd gain a small efficiency bonus. I couldn't even get one in, so gave up on that idea. I'm not sure if there's a special tool, or whether you have to take the wheel off to make it easier. Neither of those options were feasible for me.

xylarr 2026-01-09 02:20

If you have the covers that have edge clips and a center clip, make sure the middle clip spring is properly aligned - that it hasn't sort of popped out a bit. Unless the center clip works, you won't get all the outer clips to bind. Make sure the metal spring is on the outside of the five plastic tabs, and that it is in the special groove on those tabs. Align the gap in the spring with a gap between two tabs.

Add comment